|
|
|
| Microstructure and mechanical properties of welding zones of diamond saw blade |
| LUO Xi-yu1,2，XU Yan-jun2,3 ，ZHANG Guang-ning2,3 ，SHEN Xiang1,2，LIU Yi-bo2,3 |
1. China Iron and Steel Research Institute Group， Beijing 100081， China
2. Advanced Technology and Materials Co.， Ltd.， Beijing 100081， China
3. Beijing Gang Yan Diamond Products Company， Beijing 102200， China |
|
|
|
|
Abstract The transverse section division of welding seam， morphology， microstructure， composition and phase， hardness and bending strength of laser welding and brazing were analyzed， the samples were from butt-welded steel matrix and powders sintering segments of diamond saw blade. The cause of the laser welding pores was also stated. Results show that the fine-arrangement column grain and residual pores exist in the laser welding melting zone with the hardness varies linearly； while bi-phase structure， obvious dendritic structure and no cracks and pores exist in the brazing melting zone with low hardness. Acicular martensite appears in the laser welding heat-affected zone (HAZ) of steel side， while in the brazing， there is no HAZ caused by phase transition in the steel side. With specific proportioning system， there is also no HAZ caused by solid phase transition in the cutter head transition layer of laser welding and brazing segments， which remains powder sintering microstructure. The bending strength of laser welding and brazing seam are 1 175 MPa and 983 MPa， respectively， both higher than the overseas security strength requirements. The bending strength of laser welding has relatively large fluctuations， which is closely related to residual pores.
|
|
Received: 20 September 2016
Published: 15 December 2016
|
|
|
|
| [1] 罗锡裕，徐燕军，刘一波。我国人造金刚石的发展及其关键技术的进步[J]。粉末冶金工业，2016，26（1）:1~13[2] 赵博，李志宏，孙兆达。2014年超硬材料行业发展简析[C]。第十九届中国超硬材料技术发展论坛论文集，郑州，2015，11，3~6[3] 唐霞辉。激光焊接金刚石工具[M]。武汉：华中科技大学出版社，2004：11-17[4] 张柯柯，涂益民。特种先进连接方法[M]。哈尔滨：哈尔滨工业大学出版社，2007：13-17[5] 李亚江。焊接组织性能与质量控制[M]。北京：化学工业出版社，2005：89-179 |
|
|
|
2016, Vol. 26 
