| [1] Yin Haiqing, Jia Chengchang, Qu Xuanhui. Status of micro powder injection molding [J]. Powder Metallurgy Technology, 2007: 382. [2] 曹勇家. 粉末冶金产业化的重要技术方向 [J], Advanced Materials Industry, 2004: 29. [3]R.L. Coble, “A model for boundary diffusion controlled creep in polycrystalline mater- ials”, J. Appl. Phys., 1963, vol. 34, no. 6, pp. 1679-1682.[4] R.K. Bordia and G.W. Scherer, “On constrained sintering-I Constitutive model for a sintering body”, Acta Materialia, 1988, vol. 36, no. 9, pp. 2393-2397. [5] F.R.N. Nabarro, “Creep at very Low Rates”, Metall. Mater. Trans. A., 2002, vol. 33A, no. 153, pp. 213-218. [6] J. Song, T. Barriere, B. Liu, J.C. Gelin and M. Gerard, “Experimental and numerical analysis on sintering behaviours of injection moulded components in 316L stainless steel powders ”, Powder Metallurgy, accepted 2008, DOI: 10.1179/003258908X334212.[7] A. Peterson and J. Agren, “Constitutive behavior of WC-Co materials with different grain size sintered under load”, Acta Materialia, 2004, vol. 52, pp. 1847-1858.[8] R. Zhang, R.S. Engel, N.J. Salamon and R.M. German, Simulation of free sintering shrinkage and distortion behavior of stainless steel powder compacts, 2002 International Conference on Process Modeling in Powder Metallurgy & Particulate Materials, Oct. 28-29, 2002, Newport Beach, CA.[9] R.M. German, Powder Injection Molding, MPIF, 1990, Princeton, NJ. |
2017, Vol. 27 
